General Properties:
• 24 Hour cycle from time of mixing.
• Controlled 35° C or 100° C ± 2° C Curing Temperature for concrete.
• Controlled 27° C ± 2° C Curing Temperature for grey cement.
This curing tank has been designed to accommodate 150mm / 70.6mm cube
moulds and upto 36/72 cube mould can be cured in one go. The tank is
fully insulated, comes complete with a hinged lid, heater, thermostat
and re-circulated pump. Provision of two removable racks allows free
circulation of water around each mould. The pump, drain valves and
electrical equipment are housed in a compartment located at one end of
the tank. The tank is heated by an immersion heater under normal
conditions and refrigeration system for grey cement the temperature is
controlled at 35° C or 100° C ± 2° C / 27° C +2° C,expect for the 15
minutes after immersion of the freshly made specimens. This special
curing tanks have been designed for hot water curing or steam curing in
accelerated strength concrete. The interior is made from stainless
steel. The electronic programmer can control up to four test cycles with
different thermal gradients and curing time to a defined temperature
value for a complete automatic curing cycle. The control panel include a
28 column thermal printer.
Curing Tank for 6/12 moulds of 150 mm / 70.6 mm size
Curing Tank for 12/24 moulds of 150 mm / 70.6 mm size
Curing Tank for 24/48 moulds of 150 mm / 70.6 mm size
Curing Tank for 36/72 moulds of 150 mm / 70.6 mm size
