Description and Specification for Lab Tenders
Astra Scientific Computerized Temperature Control Trainer.
The Trainer provides a comprehensive experimental introduction to the
fundamentals of control engineering using an example of temperature
control.
A circulating pump delivers water within a closed circuit. A
hand-operated valve can adjust the flow rate of water. The loop also
contains a screw-in heater, a heat exchanger with fan, and three
integrated thermocouples for temperature measurement. Dead times can be
represented by the use of different lengths of process delay. A
thyristor power controller is used as the actuator. The controller used
is a state-of-the-art digital industrial controller. It can be
configured as a continuous or a switching device, and can activate the
heater via the actuator and / or the fan. The controlled variable X and
the manipulating variable Y are plotted directly on an integrated
2-channel line recorder. Alternatively, the variables can be tapped as
analogue signals at lab jacks on the switch cabinet. This enables
external recording equipment, such as an oscilloscope or a flatbed
plotter, to be connected. Process control software is optionally
available.
FEATURES:
• Experimental introduction to control engineering using an example of temperature control
• Construction of the system with components commonly used in industry
• Digital controller with freely selectable parameters: P, I, D and all combinations
SPECIFICATION:
Pump, 3-stage
• Power consumption: 70W
• Flow rate: 3,6m3/h
• Head: 4m
Screw-in heater: 2kW
Heat exchanger: approx. surface area 2,8m2
Fan
• Power output: 250W
• Flow rate: 780m3/h
• Differential pressure: 430Pa
• Speed: 2880min-1
Thermocouple: type J: 0…200°C
Thyristor power controller max. Load current: 25A
Line recorder
• 1x 4…20mA, 1x 0…20mA
• Feed rate 0…7200mm/h, stepped
Controller
• Process variables X, Y as analogue signals: 4…20mA
• Power required for operation
230V, 50Hz, 1 phase
230V, 60Hz, 1 phase